jaevan.blogg.se - Barometric pressure sensor 08 sti

Also now using triple bellow air springs for lift & load for better performance & handling feel

Double bellow bags (where application allows for space and wheel fitment) which offer more strength in rubber than sleeved bags.

Management is complete pre-fabricated - the valve block, compressor, air tank and purge valve are all pre-assembled.

12 Click Damping and height adjustable front and rear struts, for precise control of handling and feel.

Keypad shows individual bag pressure for precise control and tank pressure.

Completely digital system with individual corner control and pre-set ride heights.

Simply make two electrical and four air line connections and you are ready to roll. Fully wired, plumbed, and leak tested and packaged in an enclosure no larger than a dual subwoofer box. However if low impedance aftermarket injectors have been fitted then the correct ballast resistors MUST be fitted.This is a wireless digital air management system designed for the ultimate ease of installation. All the Subaru models this G4x plug-in is designed for use high impedance injectors so no changes are necessary.

Injectors – The G4x plug in is NOT designed to be used with low impedance injectors.

Boost control – The factory boost solenoid control wiring is used, however the boost solenoid must be upgraded on applications using an external wastegate or elevated boost levels.

On all other models the IAT sensor can be wired via the expansion connector on the ECU using the XS loom. The factory IAT wiring can be used on models that have a factory fitted IAT sensor.

Inlet Air Temp sensor (IAT) – An appropriate IAT sensor (available seperately), should be installed just prior the throttle body even on models that have a factory fitted IAT sensor near the airbox and even on Spec C models that typically have a factory fitted IAT sensor in the inlet manifold.

These sensors are capable of measuring up to 1.64Bar (23.5psi) boost. If more boost is intended to be used a higher rated MAP sensor can be connected to the existing wires.

MAP sensor – For all models the factory MAP sensor is supported.